The DRAM port code issues a dummy write to SPD page-0 i2c address
in order to select this page for the forthcoming read transaction.
If the write buffer length supplied to i2c_write is not zero, this
call is translated to 2 bus transations:
- set the target offset
- write the data to the target
However no actual data should be transferred to SPD page-0 in order
to select it. Actually, the second transation never receives an ACK
from the target device, which caused the following error report:
ERROR: Status 30 in write transaction
This patch sets the buffer length in page-0 select writes to zero,
leading to bypass the data transfer to the target device.
Issuing the target offset command to SPD page-0 address effectively
selects this page for the read operation.
Change-Id: I4bf8e8c09da115ee875f934bc8fbc9349b995017
Signed-off-by: Konstantin Porotchkin <kostap@marvell.com>
Reviewed-on: https://sj1git1.cavium.com/24387
Tested-by: sa_ip-sw-jenkins <sa_ip-sw-jenkins@marvell.com>
Reviewed-by: Ofer Heifetz <oferh@marvell.com>
Reviewed-by: Moti Buskila <motib@marvell.com>
the twin-die combined memory device should be treated as
X8 device and not as X16 one. This patch is required to
re-enable compilation after BLE (mv-ddr-marvell) firmware upgrade.
Change-Id: I41257ff2825164ebca85a84bbb8462d7b3447b97
Signed-off-by: Moti Buskila <motib@marvell.com>
Signed-off-by: Marcin Wojtas <mw@semihalf.com>
Add support for the iEi Puzzle-M801 board that is based on
the Marvell Armada 88F8040 SoC.
It supports 1 x 288-pin DIMM, DDR4 2400MHz up to 16 GB (ECC).
The iEi Puzzle-M801 board is using a custom MCU to handle board
power management. The MCU is managing the boards power LEDs, fans
and some other periferals. It's using UART for communication.
Signed-off-by: Luka Kovacic <luka.kovacic@sartura.hr>
Cc: Luka Perkov <luka.perkov@sartura.hr>
Change-Id: I0826ef8bf651b69aad5803184f20930ac7212ef8
Konstantin Porotchkin
Moti Buskila
Luka Kovacic