Add support for the PSCI CPU_ON call to allow booting secondary CPU
cores. On cold boot they need to be booted with a special register
sequence. Also, the "boot remapper" needs to be configured to point to
the BL31_BASE, so the CPUs actually start executing BL31 after reset.
Change-Id: I406c508070ccb046bfdefd51554f12e1db671fd4
Signed-off-by: Stephan Gerhold <stephan@gerhold.net>
Booting e.g. Linux in the non-secure world does not work with the
msm8916 port yet because essential hardware is not made available to
the non-secure world. Add more platform initialization to:
- Initialize the GICv2 and mark secure interrupts.
Only secure SGIs/PPIs so far. Override the GICD_PIDR2_GICV2
register address in platform_def.h to avoid a failing assert()
because of a (hardware) mistake in Qualcomm's GICv2 implementation.
- Make a timer frame available to the non-secure world.
The "Qualcomm Timer" (QTMR) implements the ARM generic timer
specification, so the standard defines (CNTACR_BASE etc)
can be used.
- Make parts of the "APCS" register region available to the
non-secure world, e.g. for CPU frequency control implemented
in Linux.
- Initialize a platform-specific register to route all SMMU context
bank interrupts to the non-secure interrupt pin, since all control
of the SMMUs is left up to the non-secure world for now.
Change-Id: Icf676437b8e329dead06658e177107dfd0ba4f9d
Signed-off-by: Stephan Gerhold <stephan@gerhold.net>
Introduce the bare mimimum base of the msm8916 BL31 port. This is
pretty much just a standard platform "skeleton" with CPU/memory
initialization and an UART driver. This allows booting into
e.g. U-Boot with working UART output.
Note that the plat/qti/msm8916 port is completely separate and does not
make use of anything in plat/qti/common at the moment. The main reason
for that is that plat/qti/common is heavily focused around having a
binary "qtiseclib" component, while the MSM8916 port is fully
open-source (and therefore somewhat limited to publicly documented
functionality).
In the future it might be possible to re-use some of the open-source
parts in plat/qti/common (e.g. spmi_arb.c or pm_ps_hold.c) but it's
not strictly required for the basic functionality supported so far.
Change-Id: I7b4375df0f947b3bd1e55b0b52b21edb6e6d175b
Signed-off-by: Stephan Gerhold <stephan@gerhold.net>
Stephan Gerhold