Enforce full include path for includes. Deprecate old paths.
The following folders inside include/lib have been left unchanged:
- include/lib/cpus/${ARCH}
- include/lib/el3_runtime/${ARCH}
The reason for this change is that having a global namespace for
includes isn't a good idea. It defeats one of the advantages of having
folders and it introduces problems that are sometimes subtle (because
you may not know the header you are actually including if there are two
of them).
For example, this patch had to be created because two headers were
called the same way: e0ea0928d5 ("Fix gpio includes of mt8173 platform
to avoid collision."). More recently, this patch has had similar
problems: 46f9b2c3a2 ("drivers: add tzc380 support").
This problem was introduced in commit 4ecca33988 ("Move include and
source files to logical locations"). At that time, there weren't too
many headers so it wasn't a real issue. However, time has shown that
this creates problems.
Platforms that want to preserve the way they include headers may add the
removed paths to PLAT_INCLUDES, but this is discouraged.
Change-Id: I39dc53ed98f9e297a5966e723d1936d6ccf2fc8f
Signed-off-by: Antonio Nino Diaz <antonio.ninodiaz@arm.com>
This patch defines:
- The full range of IO-mux register offsets relative to the base address of
the IO-mux block base address.
- The bits for muxing the UART1 TX/RX lines.
- The bits for muxing the UART6 TX/RX lines.
- The pad control pad bits for the UART
Two functions are provided to configure pad muxes:
- void io_muxc_set_pad_alt_function(pad_mux_offset, alt_function)
Takes a pad_mux_offset and sets the alt_function bit-mask supplied.
This will have the effect of switching the pad into one of its defined
peripheral functions. These peripheral function modes are defined in the
NXP documentation and need to be referred to in order to correctly
configure a new alternative-function.
- void io_muxc_set_pad_features(pad_feature_offset, pad_features)
Takes a pad_feature_offset and applies a pad_features bit-mask to the
indicated pad.
This function allows the setting of PAD drive-strength, pull-up values,
hysteresis glitch filters and slew-rate settings.
Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@linaro.org>
Antonio Nino Diaz
Bryan O'Donoghue